Square Anchor Sleeve for 2" Sign Post – 3'
Galvanized steel ground anchor for 2" x 2" square sign posts. The sleeve stays in the ground and the post slides inside, so a damaged post can be replaced in minutes without digging or new concrete. Good for parking lots, drive aisles and anywhere signs get hit by vehicles.
Specifications
- Material: Galvanized steel
- Profile: 2¼" x 2¼" square tube (fits 2" x 2" posts)
- Length: 3'
- Perforation: Pre-punched holes on 1" centers, four sides
- Compatible with: 2" x 2" perforated square sign posts (8' / 10')
Installation
- Drive the sleeve into the ground or set it in concrete, leaving 2–3" above grade.
- Slide the sign post into the sleeve.
- Secure the post with a corner bolt through the sleeve and post. Place it on the side away from traffic.
Why use a sleeve
- Fast replacement: If a vehicle hits the sign, the post fails at grade and the sleeve stays in place. Remove the damaged post and slide in a new one.
- More stable: The double-wall section at ground level adds stiffness against wind and twisting.
- Lower long-term cost: You only replace the post, not the foundation.
Sign post and hardware sold separately.
