Installation Manual ADA Truncated Dome Pad , Cast in place

Maintaining a 4-7 slump range, pour and float the concrete.

Without removing any concrete, place the tile on the curb ramp 6"-8" from the curb line (face of curb).

Tamp the tile in grid pattern across the top face, embedding the tile into the concrete using a white or (non-marring) rubber mallet or vibrate into place using a vibrating mechanism fixed with a soft base such as wood, at least 1 foot square.

Place two cinder blocks or 25lb weights on the tile to prevent floating.

 Create an edge around the perimeter of the tile using a 3/8" radius edging tool then float the concrete around the tile’s perimeter using a steel trowel.

Apply a broom-finish to the curb ramp.

After the concrete has substantially cured, remove the protective plastic wrap by cutting the plastic with a sharp knife tight to the concrete/tile interface.

If concrete bled under the plastic, a soft wire brush will clean the residue without damage to the tile surface.